This material possesses the same electrical and physical characteristics for unwinding as the "pendular" model.

Its cylinder form design permits unwinding to be made continuously with rolls that can attain 1.5 tonnes for a maximum diameter of 1800 mm.

The rolls should be monted on mandrels with square end plugs of 40 x 40 (standard).

Associated with one of our joining presses, this unwinder effectuates continuous supply for diverse processes including elastic, meshed and of course, chain and trame fabrics.

 Technical Characteristics

- Brushless motor.
- Planetary 1/5 reducer.
- 4 dial electronics.
- Automatic calculation for diameter.
- External source speed synchronisation with ascent ramp of 15 seconds.
- Maximum rotation speed of 300 rpm for the power take-off.
- Capacity to start a homogenous roll of 1.5 tonnes with an ascent ramp of 15 seconds at first start-up (diameter evaluation time). The following start-ups 5 secs.
- Three phase supply 400v.
- Mobile cylinder compensator actions an electrical detector.
- Maximum line speed 150 m/min with standard mechanics in a useful width of 3600 mm.
- Input cylinder of the motorised compensator coupled (very low) for compensation of the fabric weight contained in the introduced strands outside the equipment. Special mesh technique.
- "Above/Below" unwinding selection.
- Motorization of the keg rotation by asynchronous motor, 4.5 kW /1500 rpm.
- Asynchronous motor commanded by frequency variator.
- Cycle command by PLC.
- Grip bearings for square bar activation are activated pneumatically.
- Detector for minimum diameter.
- Passage of the roll in preparation below and passage of the current roll above.
- Design compatible with our joining presses.
- Independant electronic cabinet.
- Independant operating panel
- Standard colour RAL 5002.

On option we have:

Diverse equipment for assistance with loading or for loading full rolls or unloading heavy mandrels and the introduction of heavy mandrels into the rolls to be unwound.